Table of Contents
Advertisement
UEN00665-00
4)
Remove the release tape of dam rubber
on the glass adhesive side.
5)
Apply adhesive (15) to the outside of dam
rubber (6) of the operator's cab.
a Apply adhesive (15) with dimensions
(s) and (t) for dam rubber (6) of oper-
ator's cab (8).
Dimension (s): 10 mm
q
Dimension (t): 15 mm
q
a Apply adhesive (15) higher than dam
rubber(6).
a Apply the adhesive evenly with same
height level.
a Apply adhesive (15) additionally to
additional dam rubber(6a) of right
side window glass and additional dam
rubber(6b) of door lower window
glass.
12
50 Disassembly and assembly
7.
Install the window glass.
1)
Install window class (9), matching it to the
lines of the positioning tapes drawn in step
5.
a Since the window glass cannot be
removed and stuck again, stick it with
utmost caution.
a Stick the glass within 5 minutes after
applying the adhesive.
2)
After sticking window glass (9), press all
around of it until it sticks to the dam rubber
closely.
a Press the corners of the window glass
firmly.
PC210, 230, 240-8
Advertisement
Table of Contents
Troubleshooting
