Komatsu PC210-8 Shop Manual page 1121

50 Disassembly and assembly
4. Stick dam rubber
tape)(6) along the inside edge of the glass
sticking section.
a Do not remove the release tape of dam
rubber on the glass sticking side before
sticking the glass.
a When sticking the dam rubber, do not
touch the cleaned surface to the utmost.
a Exercise care should be taken to not to
float the dam rubber of each sticking cor-
ner.
a When sticking dam rubber (6) around a
frame, do not lap its finishing end over the
starting end. Or, make clearance of about
5mm between them(e).
1) Stick dam rubber (6) for right side window
glass (1) to the position as shown in the
figure.
a Stick dam rubber (6a) additionally to
right side window glass (1).
Positions to stick additional dam rub-
q
ber to the right side window glass:
(f): 50 mm
(g): 90 mm
(h): 250 mm
PC210, 230, 240-8
(both-sided adhesive
2) Stick dam rubber (6) for left side window
glass (2) to the position as shown in the
figure.
UEN00665-00
9