50 Disassembly and assembly
12. Shaft assembly
1)
Using push tool [4], [5], remove shaft (26).
2)
Remove bearing (27) and oil seal (29)
from cover (28).
a Only PC240LC-8, PC240NLC-8
13. Remove spacer (41) and O ring (42) from shaft
(26).
PC210, 230, 240-8
14. Remove bearing (31) from case (30).
a Apply a suitable tool on the circumference
of the outer race (thick line: Q section),
strike the tool on the circumference with
the hammer lightly, equally, by turns, and
remove the bearing gradually.
a If the outer race is made incline, bearing
becomes hard, so remove it horizontally.
UEN00661-00
25