Komatsu PC210-8 Shop Manual page 1118

UEN00665-00
Special tools
Part number
2 793-498-1210 Lifter (Suction cup)
X
3 20Y-54-13180 Stopper rubber
Removal
a Remove the window glass to be replaced
according to the following procedure.
1. Using seal cutter [1], cut the adhesive between
broken window glass (7) and operator's cab
(metal sheet)(8).
a If a seal cutter is not available, make holes
on the adhesive and dam rubber with a
drill and pass a fine wire (piano wire, etc.)
[2] through the holes. Then, grip the both
ends of the wire with priors [3], etc.(or hold
them by winding them onto something)
and move the wire to the right and left to
cut the adhesive and dam rubber.
Since the wire may be broken by the fric-
tional heat, apply lubricant to the wire.
6
Part name
t 2
t 2
50 Disassembly and assembly
(The figure shows the operator's cab of a wheel
loader.)
a If the window glass is broken finely, it may
be removed with a knife [4] and a screw-
driver.
a Widening the cut with a flat blade screw-
driver, cut the dam rubber and adhesive
with knife [4].
(The figure shows the operator's cab of a wheel
loader.)
2. Remove the window glass.
PC210, 230, 240-8