Komatsu PC210-8 Shop Manual page 1038

UEN00661-00
6) Using the tool J4, screw in the lock (25) to
the calculated depth (c).
a The screwing depth (c) is the size
between the top surface of the travel
motor and the top surface of the lock.
7) Use push-pull scale [3] to measure the
tangential force (starting force) of hub
assembly.
a The location for tangential force
(starting force) measurement is the
bolt hole for the sprocket mounting
bolt.
Tangential force (starting force): 294
q
N or less {30 kg or less}
a If the tangential force (starting force)
is not normal, disassemble again to
find the cause.
8) Install lock (24).
2
Mounting bolt:
a Do not apply the liquid adhesive to
the screw hole in the lock.
a Install the lock so that it is in full con-
tact with the travel motor spline.
16
Liquid adhesive (LT-2)
50 Disassembly and assembly
4. No.2 carrier assembly
1) Assemble No. 2 carrier assembly in the
following procedure.
1] Assemble thrust washer (23), needle
bearing (22), No. 2 planetary gear
(21), and thrust washer (20) into car-
rier (19).
a If the disassembled carrier is
reused, recover the staking
remaining on the pin hole (d) in
the carrier in advance.
a Replace thrust washer with new
one.
PC210, 230, 240-8