Komatsu PC210-8 Shop Manual page 1095

50 Disassembly and assembly
Installation
Installation is done in the reverse order of
q
removal.
[*1]
2
Hydraulic pump involute spline:
2
Mating face of the hydraulic pump case:
a Since flywheel housing is made of aluminum,
be careful not to over torque.
a Impact wrench is not applicable to use.
Refilling with oil (damper case)
q
Refill hydraulic oil through the oil filler port to
the specified level.
5
Damper case: EO30-CD Approx. 0.65l
Refilling with oil (hydraulic tank)
q
Refill hydraulic oil through the oil filler port to
the specified level. Let the oil circulate in the
hydraulic system by starting the engine. Then
check the oil level again.
5
Hydraulic tank:
3
Hydraulic tank drain plug:
58.8 – 78.5 Nm {6.0 – 8.0 kgm}
Air bleeding
q
Bleed the air from the circuit between the valve
and the hydraulic cylinder. For details, see
Testing and adjusting, air bleeding of various
parts.
PC210, 230, 240-8
Anti-friction agent (LM-G)
Gasket sealant (LG-6)
Approx. 234l (PC210, 230)
Approx. 239l (PC240)
UEN00663-02
21