Komatsu PC210-8 Shop Manual page 1048

UEN00661-00
Assembly
a Wash each part finely and check if there are not
a garbage, a crack, etc., and apply power line
oil to the sliding portion and assemble them.
a The bearing and the oil seal, which were
removed, are not re-used. New ones should be
used.
1. Oil seal
Using tool F3, install oil seal (29) into cover
(28).
a Be careful for the direction of the oil seal
(up and down).
2
Outside perimeter of oil seal:
a When press-fitting, take care so that gas-
ket sealant (LG-6) will not stick to the lip
surface of the oil seal.
a If tool F3 is not used, use the push tool
which can push outside perimeter section
(A) of oil seal (29).
a Be careful not to incline oil seal (29).
26
Gasket sealant (LG-6)
50 Disassembly and assembly
2. Using push tool [9], press fit bearing (27) into
case (30).
a Use the new bearing.
3. Install cover Assembly (33) into case Assem-
bly (32).
2
Cover mounting face:
a Be careful not to adhere gasket sealant
(LG-6) to drain port section (DP).
a Align the drain process section of cover
into the drain port section (DP).
Gasket sealant (LG-6)
PC210, 230, 240-8