Komatsu PC210-8 Shop Manual page 1109

50 Disassembly and assembly
10. Lift the work equipment Assembly, remove
plate (9) and pin (10) at the foot. [*4]
In case to remove using tool V
q
Remove plate (9) and remove pin (10) at the
foot using tool V.
a Check the number as well as locations of the
shims used.
11. Remove work assembly (11).
4
Work equipment Assembly:
PC210, 230, 240-8
PC210/230-8: 3,300 kg
Installation
Installation is done in the reverse order of
q
removal.
[*1]
Demolition spec.
q
a When tightening the locknut, make sure that
0.5 – 1.5 mm clearance is maintained between
the plate and nut after the tightening.
[*2]
2
Inside surface of bushing when assembling
pin: Anti-friction agent (LM-P)
2
Greasing after assembling the pin:
k
When aligning the position of the pin hole,
never insert your fingers into the pin hole.
a st1:resin shim (thickness 1.0mm)
a Adjust the clearance (b) between cylinder rod
(12) and plate (4) to 1.5mm or less using shims:
1.0 and 2.0 mm
Except demolition spec.
q
UEN00664-00
Grease (LM-G)
3