UEN00662-00
Assembly
Structural illustration
q
1.
Press fit bushings (9) and (10) to idler (4).
2.
Fit an O-ring and install support (7) to shaft (5)
with dowel pin (8).
8
50 Disassembly and assembly
3.
Using tool L3, install floating seals (6) to idler
(4) and to shaft (5) and support (7) assembly.
a Completely wash, de-grease and dry both
O-rings and the surfaces (shown hatched
in the illustration) of floating seals where
they contact each other.
a Coat the sliding surface of the floating seal
with oil, and be careful not to let any dirt or
dust get stuck to it.
a After inserting the floating seal, verify that
the inclination of the seal is less than 1
mm per its diameter and that the protru-
sion height shown as a in the illustration
falls within the range of 7 – 11 mm.
PC210, 230, 240-8