Table of Contents
Advertisement
UEN00662-00
3.
Install roller (4) and ring (5) to shaft (2).
a On the sliding surfaces of floating seals,
apply some oil and take care not to have
any dirt stuck on them.
4.
To make the height gap between roller (4) and
ring (5) 1.8 ± 0.2 mm, put washer [7] between
push tool [6] and roller (4), then press fit ring
(5) to shaft (2).
a The thickness of washer [7] is 1.8 ± 0.2
mm.
a Use push tool [5] to support shaft (2) on it.
5.
Using push tool [8], press fit cover (3) to roller
(4).
a De-grease, wash and dry the surfaces
where roller (4) and cover (3) fit tight.
Press fitting force (reference):
q
4
59 kN {6,000 kg} Min
50 Disassembly and assembly
6.
Fill carrier roller assembly (1) with oil and
tighten plug (9).
5
Carrier roller: 75 – 85cc (E030-CD)
3
Plug: 15 ± 5 Nm {1.5 ± 0.5 kgm}
PC210, 230, 240-8
Advertisement
Table of Contents
Troubleshooting
