Related Resources - Xilinx Spartan-3A User Manual

Chapter 12: SPI Serial Flash
13. Double-click Program.
Note:
14. Click the Programming Properties option under Category, as shown in
15. Check Verify. Unchecking Verify reduces programming time but the iMPACT
16. Check Erase Before Programming. Unchecking the Erase option reduces
17. Click OK.
18. The iMPACT software indicates successful programming, as shown in

Related Resources

Refer to the following links for additional information:
•
•
•
•
•
•
106
Step 18 occurs later.
14
16
Figure 12-18: SPI PROM Programming Options
software can only guarantee correct programming for a verified PROM.
programming time. However, Xilinx recommends erasing the PROM when
downloading a new FPGA bitstream.
The FPGA is configured with the new programming file.
Xilinx Parallel Cable IV with Flying Leads
www.xilinx.com/onlinestore/program_solutions.htm#pc
Digilent JTAG3 Programming Cable
www.digilentinc.com/Products/Catalog.cfm?Nav1=Products&Nav2=Cables&Cat=Cable
Atmel AT45DB161D DataFlash Data Sheet
www.atmel.com/dyn/resources/prod_documents/doc3500.pdf
STMicroelectronics M25P16 SPI Serial Flash Data Sheet
www.st.com/stonline/books/pdf/docs/10027.pdf
AN1579: Compatibility between the SO8 Package and the MLP Package for the
M25Pxx in Your Application
www.st.com/stonline/products/literature/an/9540.pdf
Atmel SPI Serial Flash Programmer, via RS-232 (Reference Design)
www.xilinx.com/products/boards/s3astarter/reference_designs.htm#
atmel_spi_flash_programmer
www.xilinx.com
15
17
Spartan-3A/3AN Starter Kit Board User Guide
R
Figure 12-18.
UG332_c4_29_032907
Figure 12-18.
UG334 (v1.0) May 28, 2007