Mezzanine And Ocp Cards; Removing A Mezzanine Card - Dell EMC PowerEdge C6420 Manual

Figure 52. Installing the M.2 SATA card on the SATA x16 riser
Next steps
1 If removed, install the expansion card riser assembly.
2 Install the M.2 x16 riser.
3 Install the sled into the enclosure.
4 Follow the procedure listed in
Related link
Installing the expansion card riser assembly
Installing the M.2 SATA x16 riser
Installing a sled

Mezzanine and OCP cards

The mezzanine and Open Compute Project (OCP) cards connect to the PCI bus. They are physically smaller than the standard expansion
card, and often connect to a dedicated connector on the system board.

Removing a mezzanine card

Prerequisites
NOTE: The procedure to remove the mezzanine blank is similar to the removal of a mezzanine card.
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the sled from the enclosure.
4 Remove the expansion card riser assembly.
Steps
1 Remove the screws that secure the mezzanine card to the sled.
2 Lift the mezzanine card out of the sled.
106 Installing and removing system components
After working inside your system.
Safety instructions.
Before working inside your system.