Manual Pulse Generator Input Signal (Exp+,Exp-); General Purpose Output Signals(Servo On/Off) - ICP DAS USA I-8092F Getting Started Manual

2.3.6 Manual Pulse Generator Input Signal (EXP+,EXP-)

The signals, EXP+ and EXP-, are used for manual pulsar signals. The following
diagram is an example connection for the external inputs. User can set the signals as
fixed pulse CW/CCW mode, continuous pulse CW/CCW mode, or A/B phase manual
pulsar mode by using the setting in section 3.5.
Fig. 2.15 EXP+/- connection diagram

2.3.7 General Purpose Output signals(Servo On/Off)

The following diagram is a digital output signal for driver Servo On/Off signal. The
output signal enable or disable the driver.
Fig. 2.16 Servo On/Off signal connection diagram
24
http://www.icpdas.com
I8092F Getting Started ManualVer.2.3