Section 4. Product Program Mode; Modifying Product Settings - Henny Penny Wendy’s Evolution Elite EEG-153 Service Manual

4-1. MODIFYING PRODUCT
SETTINGS
May 2012

SECTION 4. PRODUCT PROGRAM MODE

This mode allows you to program the following:
• Change Product Name
• Assign Button
• Change Times & Temp
• Change Cook ID
• Alarms
• Quality Timers
1. Press and hold
display, followed by "ENTER CODE".
2. Enter code 1, 2, 3 (first 3 product buttons). "PRODUCT"
and "PROGRAM" show in the displays, followed by
"SELECT PRODUCT' and "-P 1-" (ex: NUG).
Change Product Names
3. Use the ▲ and ▼ buttons to scroll through the 40
products, or press the desired product button.
4. Press ► button and "NAME" shows in the left display
and the product (ex: NUGGETS) shows in the right display.
5. Press √ button and the first letter in the name flashes. Press
a product button and the flashing letter changes to the
letter under the product button that was pressed. For example,
if
Press the same button again and the flashing letter changes to a
"B". Press it again and the flashing letter changes to a "C".
Once the desired letter shows in the display, press ► button
to continue to the next letter and repeat the procedure.
Press and hold the right X button to exit Program Mode, or
press ► button to continue on to "COOK TIME".
Assign Button
6. Press ► button until "ASSIGN BTN" shows in the display,
along with the product (ex: NUGGETS). If this product al-
ready has a product button assigned to it, that LED will be lit.
To assign other product buttons to that product, press and hold
the product button for 3 seconds and that LED stays lit. To
remove a product from a button, press and hold the product
button with a lit LED and the LED goes out.
• Include in Filter Count (Global)
• Filter at X no. of loads (Mixed)
• Load Compensation
• Load Compensation Reference
• Full Heat
• PC Factor
button until "PROG" shows in the
is pressed, the flashing letter changes to an "A".
4-1
Model EEG-153, 154
first