Module Add-on Options
The library requires a minimum 2N power with 240 VAC to support dual robotics.
■
The library must have two TallBots. To order an additional TallBot, see
■
TallBots"
Access Expansion Module (AEM)
AEMs can provide bulk loading and dual robotics support. AEMs can only be placed
at the ends of the library. An AEM cannot be placed directly to the left of the Base
module; there must be a module in between.
Table 9–5
Description
AEM for Left Side, 234 bulk loading CAP
AEM for Right Side, 234 bulk loading CAP
Options:
One AEM supports bulk loading capability only, dual robotics is not supported. It
■
is recommended to install a single AEM on the left for maximum storage slot
capacity.
Two AEMs support bulk loading and dual robotics.
■
Requirements for Dual Robotics:
If two PEMs are not installed, two AEMs are required to support dual robotics.
■
The library requires a minimum 2N power with 240 VAC to support dual robotics.
■
The library must have two TallBots for dual robotics. To order an additional
■
TallBot, see
Dual TallBots
Dual TallBots increase efficiency and provide redundancy if a robot becomes inactive.
Table 9–6
Description
Dual TallBot
Requirements:
Two AEMs or two PEMs are required to support dual robotics.
■
The library requires a minimum 2N power with 240 VAC to support dual robotics.
■
Module Add-on Options
Module add-on options include tape drive arrays, CAPs, window arrays, and an
operator panel which can be added to a module. Some options are only compatible
with a specific module. Therefore, read the options and requirements carefully.
Tape Drive Arrays
Tape drive arrays may be ordered for the Base module or DEM.
9-4 StorageTek SL3000 Systems Assurance Guide
on page 9-4.
Access Expansion Module Part Numbers
"Dual TallBots"
on page 9-4.
Dual TallBots Part Numbers
ATO
PTO
SL3000-LEFTAEM-Z
XSL3000-AEM-LFT-N
SL3000-RIGHTAEM-Z XSL3000-AEM-RT-Z-N
ATO
PTO
SL3000-DUALBOT-Z
XSL3000K-DUALBOT-N
"Dual