Setcp - TechnoKom AutoGRAPH-ST Command Manual

AutoGRAPH- ST – Remote Control Command

SETCP

Command
Name
Supported with firmware
Description
Command formats:
password SETCP=status,lat,lon,radius,flags;
parameters of the command:
 status – specify the following value:
0 – to disable geofence control;
1 – to enable geofence control.
 lat – latitude of the geofence midpoint. It must be specified decimally in degrees from -
90 to 90;
 lon – longitude of the geofence midpoint. It must be specified decimally in degrees from
-90 to 90;
 radius – radius of the geofence in meters. Minimum value is 200 m, maximum – 1000
km.
 flags – geofence settings. The flag must be a decimal number computed from binary
number. Every bit of binary number is matched to one of the following setting in order as
listed (from left to right):
srv – data transferring to the server when entering to/exiting geofence: 0 – disables the
transferring, 1 – enables the transferring.
smtp – Email sending when entering to/ exiting geofence: 0 – disables the sending, 1 –
enables the sending.
sms – SMS sending when entering to/ exiting geofence: 0 – disables the sending, 1 –
enables the sending.
in – control of entering to the geofence: 0 – disables the control, 1 – enables the control;
out – control of exiting the geofence: 0 – disables the control, 1 – enables the control;
For example, "00110" string enables SMS sending when entering to the geofence.
Decimal value of the "00110" is number 6.
48
SETCP
Geofencing
AGST-1.16 and higher
Command provides to specify geofence settings and
enable it control. AutoGRAPH-ST supports only circle
geofences.