AutoGRAPH- ST – Remote Control Command
GPSEN
Command
Name
Supported with firmware
Description
Command format:
password GPSEN=status;
parameters of the command:
status – specify following value:
0 – to disable data recording;
1 – to enable data recording;
Sample command:
5672 GPSEN=1;
Sample reply:
#SECURESETUP=1;
Data collection is enabled in the device.
46
GPSEN
Data recording option
AGST-1.11 and higher
Command enables position data recording, which
means that the device will switch to the tracking mode,
acquire position and record that data in internal memory.
In this case the device doesn‟t send the obtained data to
customer. The collected data can be sent to data server
in the next data transmission period. This data is sent
only to server.