AutoGRAPH- ST – Remote Control Command
FASTMOVEDETECT
Command
Name
Supported with firmware
Description
Command format:
password FASTMOVEDETECT= status;
parameters of the command:
status – send quick notification:
0 – disabled. In this case the device will send 1 notification about motion detection, only
after the position acquisition;
1 – enabled.
Sample command:
5672 FASTMOVEDETECT=1;
Sample reply:
FASTMOVEDETECT=1;
The device is set up to send quick notification when accelerometer triggers.
42
FASTMOVEDETECT
Quick accelerometer notification
AGST-1.32 and higher
Command is intended to enable quick notification when
accelerometer detects motion start or other affects.
When this option is enabled, the device will send a
notification without position data immediately after the
motion detection. When the position data becomes
available, it sends second notification with device current
position coordinates. This function provides on-time
delivery of notification to a customer.