Table of Contents
Advertisement
ACCLEN
Command
Name
Supported with firmware
Description
Command format:
password ACCLEN=status;
parameters of the command:
status – specify following value:
0 – to disable accelerometer;
1 – to enable accelerometer.
Sample command:
5672 ACCLEN=1;
Sample reply:
#ACCLEN=1;
The device accelerometer is enabled.
The AutoGRAPH-ST device is equipped with an internal accelerometer optionally. So the
configuration commands intended for the device accelerometer are applicable only for
AutoGRAPH-ST devices equipped with accelerometer.
To check if the device is equipped with internal accelerometer, read its configuration using
the AGSTConf application or send SMS request «ACCLEN=?;».
If the device is equipped with accelerometer, the accelerometer configuration option will
be available in the AGSTConf application. When sending SMS request, the following reply
will be returned if the device is equipped with internal accelerometer:
#ACCLEN=status,exist;
where:
status – current state of accelerometer: 0 – disabled, 1 – enabled.
exist – accelerometer availability: 0 – device is not equipped with accelerometer, 1 –
device is equipped with accelerometer.
For example, the reply "#ACCLEN=0,1;" means that the device is equipped with internal
accelerometer, but it is disabled.
ACCLEN
Use accelerometer to detect motion
AGST-0.75 and higher
Command is intended to enable the device internal
accelerometer which allows motion detection and
detection of any affects the device.
AutoGRAPH-ST – Remote Control Command
39
Advertisement
Table of Contents
