Table of Contents
Advertisement
AutoGRAPH- ST – Remote Control Command
ACCLSETUPLEV
Command
Name
Supported with firmware
Description
Command format:
password ACCLEN= scale,threshold;
parameters of the command:
scale – accelerometer range:
0 – +/-2g;
1 – +/-4g;
2 – +/-8g;
3 - +/-16g;
threshold – motion detection level, providing sending the notification to a customer, if
an affect detected by accelerometer is higher than the specified threshold. The threshold
must be specified in mg.
Sample command:
5672 ACCLSETUPLEV=0,1062;
Sample reply:
ACCLSETUPLEV=0,1062;
The device accelerometer has following settings: measuring range is +/-2g, detection
threshold – 1062mg.
40
ACCLSETUPLEV
Accelerometer settings
AGST-0.75 and higher
Command
is
intended
accelerometer.
to
configure
the
device
Advertisement
Table of Contents
