Digital Outputs (Control Panel: Menu Par  P7) - Honeywell HVAC232 Series Applications Manual

10.7 Digital outputs
(Control panel: Menu PAR
RO1 signal selection
RO2 signal selection
DO1 signal selection
Table 51.Outputsignals via RO1, RO2 and DO1
Setting
0 = Not used
Output is not in operation.
1 = Ready
The frequency converter is ready to operate.
2 = Run
The frequency converter operates
(motor is running).
3 = Fault
A fault trip has occurred.
4 = Fault inverted
A fault trip has not occurred.
5 = Warning A warning is active.
6 = Reversed The reverse command has been selected, out-
put frequency to the motor is negative.
7 = At speed The output frequency has reached the set
reference.
8 = Motor regulator All motor monitoring functions are activated
active (e.g., over current regulator, over voltage regu-
lator, under voltage regulator, etc.)
9 = FB Control
Output can be controlled with B13 in the
Word.B13 fieldbus control word.
10 = FB Control
Output can be controlled with B14 in the
Word.B14 fieldbus control word.
11 = FB Control
Output can be controlled with B15 in the
Word.B15 fieldbus control word.
Application manual HVAC232/402 | Document 27-652 | Issue ENG06 | 2019-08-07
P7)

Signal content Setting
12 = Output
Output frequency is over / under the limits,
frequency superv. set with parameters P11.1 and P11.2.
13 = Output
Motor torque is over/under the limit, set with
torque superv. parameter P11.3 and P11.4
14 = Unit
Unit temperature is over / under the limits,
temperature superv. set with parameters P11.5 and P11.6.
15 = Analogue
Analogue inputs set with parameter P11.7 is
input superv. over / under the limits, set in P11.8 and P11.9.
16 = Preset Speed
Each of preset speeds are activated.
Active
17 = External External Brake control.
Brake control
Closed = Brake open,
Open = Brake closed.
18 = Keypad
Keypad is set as the current control place.
control active
19 = I/O control
I/O is set as the current control place.
active
20 = Fire mode
active
21 = Temperature
supervision
Signal content
119