Power Indicators - Extron electronics DMS 1600 User Manual

View button (see
E
View button has one primary function (❏) and four secondary functions (•):
Selects and indicates View-only mode, which displays the current configuration.
❏
NOTE: View-only mode also provides a way to mute and unmute the outputs.
• In the I/O Group mode, selects group 3 and indicates its selection.
• With the Esc button, commands the front panel system reset.
• Selects 38400 baud for the RS-232/RS-422 port in Serial Port Selection and
Configuration mode and indicates its selection.
With the Preset button, indicates that the front panel lock has been toggled on or
•
off.
Esc button — The Esc button has two primary functions (❏) and three secondary
F
functions (•):
Cancels operations or selections in progress and resets the front panel button
❏
indicators.
NOTE: The Esc button does not reset the current configuration or any presets.
Flashes once to indicate that the escape function has been activated.
❏
• In the I/O Group mode, selects group 4 and indicates its selection.
• Selects 115200 baud for the RS-232/RS-422 port in Serial Port Selection and
Configuration mode and indicates its selection.
With the Enter button, toggles the front panel lock on or off.
•

Power Indicators

DMS 1600 and DMS 3600
Primary and Redundant Power Supply LEDs —
G
Green — Indicates that the associated power supply is operating
within normal tolerances.
Red — Indicates that the associated power supply is operating
outside the normal tolerances, has failed, or (DMS 3600 only) is not
installed (see
(DMS 1600 and DMS 3600)
Unlit (DMS 1600 Redundant LED) — No power supply is installed.
DMS 2000 and DMS 3200
Power LED — Indicates that the power supply is operating within normal
H
tolerances.
figure 12 on page 14 through
Removing and Installing the Power Supply Module
on page 103 to replace the power supply).
DMS 1600, DMS 2000, DMS 3200, and DMS 3600 • Operation
figure 15 on page 15) — The
POWER SUPPLY
REDUNDANT
PRIMARY
POWER
19