Configuring The Serial Card; Configuring The Ethernet Interface; Configuring The Ethernet Port - 3Com SuperStack II PathBuilder S330 Reference Manual

110 C 4: C
HAPTER ONFIGURING
Configuring the Serial
Card
Configuring the
Ethernet Interface
Configuring the
Ethernet Port
P B S330/S310 M
ATH UILDER ODULES
The only type of configuration you can perform on the serial card is to put it in
service or out of service. To set the administrative status of the serial card, follow
these steps:
1 From the Configuration Management menu, shown earlier in Figure 50, select
[1] Manage Card to display the List Card menu, shown in Figure 51.
2 From the List Card menu, select [5] SIM to display the SIM Configuration Port/Card
Selection menu, shown in Figure 76.
3 Select [2] Card Configuration to display the SIM Card Configuration menu, shown
in Figure 80.
Figure 80 Configuring the Serial Card
4 Select [1] Set Admin. Status to put the Ethernet card in service or out of service.
The maximum frame size is fixed at 8KB.
Configuring the Ethernet interface involves the following tasks:
Configuring the Ethernet port
n
Configuring the Ethernet card
n
Configuring the bridge
n
The only type of configuration you can perform on the Ethernet port is to put it in
service or out of service. To set the administrative status of the Ethernet port,
follow these steps:
1 From the Configuration Management menu, select [1] Manage Card to display the
List Card menu, shown earlier in Figure 51.
2 From the List Card menu, select [6] ETHERNET to display the Ethernet
Configuration Port/Card Selection menu, shown in Figure 81.
, P , A
ORTS AND PPLICATIONS