Configuring The Voice Compression Module; Configuring Vcm Ds0 Channels - 3Com SuperStack II PathBuilder S330 Reference Manual

Configuring the Voice
Compression Module
Configuring VCM DS0
Channels
Figure 98 CBR Card Configuration Menu
4 Select [1] Set Admin Status and enter 2 to put the CBR card in service or 1 to take
it out of service.
The optional Voice Compression module (VCM) consists of one T1/E1 interface
which you connect to a PBX trunk. The T1/E1 interface's 24/31 DS0 channels can
carry individual voice, fax, modem, or data connections—or you can bundle
multiple DS0s to provide connections for high-rate applications such as video
conference or multiple-link PPP. For CCS, a DS0 is used as an ISDN D-channel for
carrying signal messages.
Configuring the VCM involves the following tasks:
Configuring the channels
n
Configuring the T1/E1 port
n
Configuring the VCM card
n
The following subsections describe these tasks. For details about configuring
virtual circuits for the VCM, see "Configuring Virtual Circuits" later in this chapter.
To configure VCM DS0 channels, follow these steps:
1 From the VCM Configuration menu, shown earlier in Figure 100, select
[1] Channel Configuration.
The following prompt appears:
Enter Channel (1-8):
2 Enter the number of the channel you want to configure.
After you enter the channel number, the VCM Channel Configuration menu
opens. Figure 99 shows a representative VCM Channel Configuration menu.
Configuring the Voice Compression Module 129