Supplementary Regulatory Information; Fcc Part 68 Statement - 3Com SuperStack II PathBuilder S330 Reference Manual

3com wan access switch reference guide
Hide thumbs Also See for SuperStack II PathBuilder S330:
Table of Contents

Advertisement

FCC Part 68 Statement

Canadian CS-03
Approval Information
S
UPPLEMENTARY
I
NFORMATION
This section describes the compliance of the SuperStack
®
and the SuperStack
II PathBuilder
S330/S310) with FCC, Industry Canada, and CE regulations.
This equipment complies with Part 68 of the Federal Communications
Commission (FCC) rules. On the product is a label that contains the FCC
registration number for this device. If requested, you must provide this
information to the telephone company.
This equipment is designed to be connected to the telephone network or
premises wiring using a compatible modular jack which is Part 68 compliant.
See installation instructions for details.
If this device causes harm to the telephone network, the telephone company
will notify you in advance that temporary discontinuance of service may be
required. The telephone company may request that you disconnect the
equipment until the problem is resolved.
The telephone company may make changes in its facilities, equipment,
operations, or procedures that could affect the operation of this equipment. If
this happens, the telephone company will provide advance notice in order for
you to make necessary modifications to maintain uninterrupted service.
If you experience trouble with this equipment or for repair or warranty
information, please follow the applicable procedures explained in the Technical
Support section of this manual (Appendix A).
The Industry Canada label identifies certified equipment. This certification means
that the equipment meets certain telecommunications network protective,
operational, and safety requirements. Industry Canada does not guarantee the
equipment will operate to your satisfaction.
Before installing this equipment, you should ensure that it is permissible to be
connected to the facilities of the local telecommunications company. You must
also install the equipment using an acceptable method of connection. In some
cases, the inside wiring associated with a single line individual service may be
extended by means of a certified connector assembly. You should be aware that
compliance with the above conditions may not prevent degradation of service in
some situations.
R
EGULATORY
®
®
S310 WAN access switches (PathBuilder
®
II PathBuilder
S330

Advertisement

Table of Contents
loading

Table of Contents