Pathbuilder S330/S310 Alarm Messages - 3Com SuperStack II PathBuilder S330 Reference Manual

166 C 5: P B
HAPTER ATH UILDER
PathBuilder S330/S310
Alarm Messages
S330 D P
IAGNOSTICS AND ERFORMANCE
2 Select [1] Display Current Alarms to view a list of current alarms, as shown in
Figure 134.
Figure 134 Sample Current Alarm Display
To determine whether or not an alarm-generating condition has been resolved,
clear the current alarms and recheck the Display Current Alarms screen, as follows:
1 From the Display Current Alarm screen, press [Esc] to return to the Fault
Management menu.
2 Select [2] Clear Current Alarms.
3 Enter y in response to the confirmation prompt to clear the current alarms.
4 Select [1] Display Current Alarms to return to the Display Current Alarms screen.
Alarm-generating conditions that are still present will regenerate alarms on the
n
Display Current Alarms screen.
Alarm-generating conditions that are no longer present will no longer generate
n
alarms on the Current Alarm screen.
This section lists the alarm messages, meanings of the alarm messages, and
troubleshooting tips for the major errors reported from each of the PathBuilder
S330/S310 interfaces. It contains the following subsections:
MCPU and CTX Module (System) Alarms
n
Alarms Common to Several Interfaces
n
DS1/E1 UNI Module Alarms
n
DSX-1/E1 CBR Module Alarms
n
SIM Alarms
n
Voice Compression Module Alarms
n
S
TATISTICS