Table of Contents
Advertisement
2.2. Inserting a Node Module
ESD-Sensitive Device!
Take all necessary ESD protection measures.
1.
Holding the handle, insert a node module.
2.
Push it in until the safety lock clicks in place.
3.
Wait for the power LED of the processor node module to become steady green (30 to 120 seconds): the node is
powered on and ready to use.
2.3. System Behavior upon Hot Swap
The system is electrically designed to support a surprise extraction. However, this type of
extraction is not recommended and could affect system performance and functionalities.
When a hot-swap procedure is performed on MSP804x nodes, the systems and functionalities could be affected.
www.kontron.com
MSP8040 Series User Guide Rev. 1.2
// 22
Advertisement
Table of Contents
