Setting The Call Times; Setting Call Divert; Setting Activations On Call - Comelit VIP System Installer Manual

The complete internet protocol system simple and versatile

Hide thumbs

Table Of Contents

Table of Contents

Setting the call times

Advanced Settings

Lock-release key

OFF key disabled

Call times

Call divert

◊ Awaiting reply (in):

wait time in which a call is ended if it is not answered.

◊ Awaiting ans.serv.act.:

maximum time after which the answering service is activated if a call is not answered.

◊ Conversation:

maximum conversation duration.

◊ Pause:

maximum time a call can be put on hold.

◊ Awaiting reply (out):

wait time in which, if there is no answer, the call is ended.

Setting call divert

This function can be used to divert incoming calls to another switchboard on the list.

Advanced Settings

Lock-release key

OFF key disabled

Call times

Call divert

Setting activations on call

When this function is active, on receipt of a specifi c type of call the switchboard will activate the output of an actuator module Art. 1443, or of an

extension unit connected to it.

The following example illustrates the function confi guration procedure for an Alarm call; the same also applies for the other types available in the menu.

Advanced Settings

OFF key disabled

Call times

Call divert

Activations on call

In the address fi eld, enter the VIP address of actuator Art. 1443.

In the module fi eld, select whether to activate an output on board the actuator Art. 1443 (Builtin), or specify the number of the expansion device with

which you want to interact. In the output fi eld, enter the exact number of the output you want to activate (1 or 2 for module art.1443, or 1 to 10 for an

expansion device).

Set call times

Expressed as min:sec