Table of Contents
Advertisement
If the Lock-release function is selected:
1. Select the mode for which you wish to change the function using
and press
to confi rm.
CONFIGURE RELAY
Configuration during call
Configuration at rest time
2. Select the fi elds which can be changed using
value using
,
or
.
RELAY DURING CALL
Active:
Interlocutor
Door
Active:
Interlocutor
Door
Left
Right
If the Actuator function is selected:
ACTUATOR SETTING
Active:
ViP address:
0 0 0 0 0 1 0 1
Module 255
Output
0 1
Left
Right
• The VIP address fi eld identifi es actuator module Art. 1443.
• In the Module fi eld, select whether to activate the relays on board
the module (255) or those on the expansion module Art. SK9071
connected to it (1 to 10) .
• In the Output fi eld, select the relay you intend to activate . 1 or 2 if
you enter 255 in the module fi eld. 1 to 10 if you enter an expansion
module in the module fi eld.
If the Activate Output function is selected:
The button will control an NC/NO output which can be programmed as
monostable or bistable.
For output confi guration, see page 56.
,
,
and change the
Relay 1
0 0 0 0 0 0 0 0
Relay 1
0 0 0 0 0 0 0 0
• Confi guring the key button
1. Access the installer menu.
2. Select the Confi gure buttons menu by pressing
to access it.
INSTALLER MENU
Configure buttons
3. Press
to access it.
CONFIGURE BUTTONS
1
2
Configure key button
4. Select the mode for which you wish to change the function using
and press
to confi rm.
CONFIGURE RELAY
Configuration during call
Configuration at rest time
5. Select the fi elds which can be changed using
value using
,
or
.
RELAY DURING CALL
Active:
Interlocutor
Door
Active:
Interlocutor
Door
Left
Right
6. Press
to exit and save the changes.
,
and press
,
,
and change the
Relay 1
0 0 0 0 0 0 0 0
Relay 1
0 0 0 0 0 0 0 0
53
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the VIP System and is the answer not in the manual?