Control Via Remote Contacts - BONFIGLIOLI Vectron ACTIVE CUBE Manual

13.4.4
In the operation mode
frequency inverter is controlled via the control word in PZD1, with the bits 0 to 9 cor-
responding to the contact inputs S1IND to S6IND, multifunctional input MFI1D and the
inputs EM-S1IND to EM-S3IND of an expansion module.
In the use of the remote contacts, the frequency inverter behaves in the same way as
in control via the hardware contact inputs. The meaning of these inputs can be taken
from the operating instructions.
Note:
State machine:
The values displayed in the states are reflected in the status word (Bit 0 to 6) in PZD1.
Note:
44
44

Control via remote contacts

Local/Remote
Release is only possible if the hardware release is available via the digital
inputs STOA and STOB.
Power on
Initialisation
Ready
0x23
Enable Enable
off
on
Operation
enabled
0x27
The inputs set via the control word can be observed with the help of pa-
Digital Inputs
rameter
played as being set if the hardware release is available and the control
word/Bit 0 has been set.
If the data set switch-over is used, please make sure that parameter
cal/Remote
412 is set to operation mode "2 – Control via remote con-
tacts" in all the data sets used.
CM-PDPV1
CM-PDPV1
412 = "2 - Control via remote contacts", the
Quitt fault
from any state
250. Digital input "Inverter Release" is only dis-
Fault
0x08
Lo-
08/08
08/08