Introduction - BONFIGLIOLI Vectron ACTIVE CUBE Manual

2
This document describes the features of the Profibus-DP communication module CM-
PDPV1 for frequency inverters of the ACU series.
For the Profibus-DP connection, the frequency inverter must be equipped with the
Profibus-DP communication module CM-PDPV1. The Profibus component CM-PDPV1 is
enclosed with the inverter as a separate part and must be fitted by the user. This is
described in the chapter "Installation".
Note:
The Profibus component CM-PDPV1 has the ident number 0x0B2C (hexadecimal).
The device's data set file has the designation BV__0B2C.GSD and is attached to the
appendix of this documentation. The identification number and designation of the GSD
file have been assigned by the Profibus user organization in Karlsruhe Germany.
Attention! With the help of the Profibus-DP communication module CM-PDPV1 it is
8
8

Introduction

These instructions are not to be understood as fundamental information
on the Profibus-DP. They presuppose underlying knowledge of the me-
thods and modes of effect of the Profibus-DP on the part of the user.
In some points, setting and display possibilities are described alternative-
ly to the control unit KP500 via the VPlus PC program. Operation of a PC
with the VPlus program on the frequency inverter with use of the Profi-
bus component CM-PDPV1 is only possible via an optional interface
adapter KP232 on the slot of the control unit KP500.
possible to access ALL parameters of the frequency inverter from the
external control unit. Control of the access via the Control Level (Para-
meter 28) as with the control unit KP500 or the VPlus PC software does
not exist. A change of parameters with an unknown meaning to user can
lead to the inoperability of the frequency inverter.
CM-PDPV1
CM-PDPV1
08/08
08/08