Xilinx Zynq-7000 Getting Started Manual page 4

Date Version
02/12/2013 3.0.1
05/14/2013 4.0
08/12/13 5.0
Draft
10/21/13 6.0
Draft
4
Removed stray internal draft banner from the cover page, and from the first page in
each chapter and appendix.
Deleted "Key Features of the ZC702 Evaluation Board" section. The
Features, page 27 were updated for the Programmable Logic (PL) to "One
Performance Monitor". The required binaries in
Requirements, page 28 were updated to include "zynq-zc702-base-trd.dts".
Port "P1" was labelled in Figure
illustrate the QT-based GUI and minimized GUI mode. In
Demonstration for 720p Video Resolution, page
running QT based GUI in 720p mode and running the UART Menu based
Demonstration Application in 720p mode.
Updated document for Vivado Design Suite 2013.2. Added Command Line Application
block to Figure 3-1. Updated binaries under
Updated commands under
Running the UART Menu-Based Demonstration
Demonstration for 720p Video
Updated Requirements to Get Started
Updated Evaluating AMS
Updated document for Vivado Design Suite 2013.3. Updated
and Figure 3-9. Updated zynq> commands (changed sobel_qt to run_sobel.sh).
www.xilinx.com
Revision
Base TRD Hardware Setup
3-2. Figure 3-6 and
38, the instructions were updated for
Base TRD Hardware Setup
Running the Qt-Based GUI Application
Application, and
Resolution. Updated
(modified steps 3 and 4 and deleted step 5).
steps 2 and 3.
ZC702 and ZVIK Getting Started Guide
UG926 (v6.0) December 17, 2013
Base TRD Key
Figure 3-7 were replaced to
Running the Video
Requirements.
Demonstration,
Running the Video
Figure 3-9 and Figure 4-1.
Figure 3-6, Figure
Send Feedback
3-7,