Tires; Lubrication; Chain Tension - Landoll SSB-8 Operator's Manual

Tires

Recommended inflation pressure is a follows:
9.5 L-15 - 8 Ply Rating, 32 psi

Lubrication

• All machines have a grease fittings on each bearing
end of the front and rear rollers. Pull type machines
have a grease fitting on each wheel arm pivot as well.
See Figures 4-1 and 4-2.
• Oil roller chains periodically.
• Repack wheel bearings annually.
• Grease all bearings every 20 working hours.
• Grease wheel arms every 4 hours when machine in
constantly raised.
• When the machine is not used for some time, exposed
portions of the hydraulic cylinder rods must be cleaned
and covered with a thick coat of grease to prevent
corrosion, which will damage the seals.
Figure 4-1: Lube Points (1 of 2)
20
Hours
4
Hours
Figure 4-2: Lube Points (2 of 2)

Chain Tension

To adjust the transmission chain, first loosen the 5/8" idle
axle bolt and then use the clevis bolt to obtain about 1/8"
-1/4" sag. Re-tighten the axle bolt. Be careful not to
over-tighten this chain. See Figure 4-3.
Adjust the chain between the front roller and transmission
to have approximately 2" of total deflection. See
Figures 4-3 & 4-4.
Figure 4-3: Loosen Idle Bolt
MAINTENANCE
20
Hours
Clevis Drawbolt
Idler Axle Bolt
Movable Idler
Front Roller
4-3