ASSEMBLY INSTRUCTIONS
Seed Shaft Sensor Kit - Brome Box
At the transmission/left side of seeder remove 1/4 x 1-1/2
Roll Pin from Seed Shaft Coupler. Replace Coupler with
Coupler with magnet, insert existing Roll Pin
Insert Sensor into Shaft Sensor Bracket slot.
2-20
Figure 2-21: Brome Box Sensor Brackets - 1 of 2
Insert two 5/16-18 x 1" bolts through transmission case.
Align the Shaft Sensor Bracket with the two Bolts. Secure
with Flat Washers, Lock Washers and Nuts.
Slide/Position Seed Shaft Sensor so it is 1/8" from the
magnet. See Figure 2-24. Tighten both Retaining Nuts.
1P480rev0718