Speed-Up Kit - Landoll SSB-8 Operator's Manual

Speed-Up Kit

Seed rates can be doubled by using a 26 tooth sprocket
and following the procedure below:
1. Loosen and remove both drive chains.
2. Remove 1/4" x 2 1/4" Bolt, Lock Washer and Nut from
#55 chain (large) sprocket hub on front transmission
shaft.
3. Remove the roll pin from #40 chain (small) sprocket
hub on the front transmission shaft.
4. Remove the bearing bolts from the right side of the
transmission shaft.
5. Remove the locking collar from the left side of the
front transmission shaft.
6. Move the shaft far enough to the right to remove the
small sprocket.
7. Install the new 26 tooth sprocket.
8. Replace all items (except #40 chain) in reverse order.
9. Add extra links to #40 chain.
10. Adjust chain tension. See Figure 4-3.
Figure 2-18: Speed Up Kit
ASSEMBLY INSTRUCTIONS
2-17