Seed Shaft Sensor Schematic - Landoll SSB-8 Operator's Manual

Seed Shaft Sensor Schematic

Mount Console with Clutch Control on Tractor.
1. Route Console Harness with 9 Pin Connector to the
Seeder Harness.
2. Attach 3 Pin Power Plug to tractor.
3. Secure console harness with Tie Straps.
4. Route Seeder Harness along front frame of seeder.
Ensure plug labeled Electric Clutch Power is on the
left side.
5. On left side connect plug labeled "Electric Clutch
Power" to the Electric Clutch lead. If you do not have
an Electric Clutch, seal the plug end using a 2-Pin
Shroud and Cavity Plug to protect it from the
environment. See Figure 2-25.
Seeder Console
with Clutch Control
Seed Shaft Sensor
Clutch included
with Seeder
6. Connect plug labeled "Left Front Seed Shaft Sensor"
to the left front Seed Shaft Sensor.
7. If you have a double box seeder connect the plug
labeled "Left Rear Seed Shaft Sensor" to the left rear
Seed Shaft Sensor. Otherwise, seal the plug end
using a 3-Pin Tower and Cavity Plugs to protect it
from the environment.
8. Repeat for the right side.
9. Secure all harnesses and wires with cable tie and tie
straps.
Power Plug
Seeder Harness
Seeder SensorHarnessSchematic
Figure 2-25: Sensor Schematic
ASSEMBLY INSTRUCTIONS
Cable Tie
Cavity Plug
2 Pin Shroud
Seed Shaft Sensor
Harness End
without clutch
2-23