Landoll SSB-8 Operator's Manual page 47

4. Install the left and right boxes as shown. Left box
fastens to transmission with two 5/16" x 1-1/2" and
two 3/8" x 1" Bolts, Lock Washers and Nuts. Left box
assembly is the one with one hole in the left end of
the 5/8" square shaft. This hole is used only for a
shipping wire. See Figure 2-29.
5. Install 4C488 Washers to hold the bushing. See
Figure 2-30.
Figure 2-28: Extended Supports
Figure 2-29: Left and Right Agitator Boxes
ASSEMBLY INSTRUCTIONS
6. Position the shift handles on rear of boxes so the pin
in the bottom of each handle engages the slotted
hole in the slide. Attach handles to shift plates using
1/2" x 1" Pivot Bolt and Flat Washer. Tighten Bolt just
so the handle can move easily and then lock the Bolt
by installing Set Screw into tapped hole in cast iron
shift plate. See Figure 2-31.
2-25