ASSEMBLY INSTRUCTIONS
Agitator Box
Installation of the Agitator (Brome) Box: Loose parts are
shipped in a bag assembly placed in the left seed box.
1. Remove bolts holding rear panel to deflector shield
assembly and reverse rear panels so that upper lips
flare rearward instead of forward. See Figure 2-26.
2-24
2. Install coupling on transmission output shaft and
3. Loosen U-Bolts which fasten front seed box to frame
Figure 2-26: Deflector Shield
Figure 2-27: Coupling Transmission
secure with 1/4" x 1-1/2" Roll Pin. See Figure 2-27.
at center and right end. Replace center and right end
support brackets with extended supports which also
have holes for mounting a 2nd box (part 9K853 and
9K854). See Figure 2-28.
1P480rev0718