Seed Shaft Sensor Schematic - Landoll BRILLION SL Series Operator's Manual

ASSEMBLY INSTRUCTIONS

Seed Shaft Sensor Schematic

Mount Console with Clutch Control on Tractor.
1. Route Console Harness with 9 Pin Connector to the
Seeder Harness.
2. Attach 3 Pin Power Plug to tractor.
3. Secure console harness with Tie Straps.
4. Route Seeder Harness along front frame of seeder.
Ensure plug labeled Electric Clutch Power is on the
left side.
2-14
Figure 2-14: Seed Shaft Sensor Schematic
5. On left side seal the plug that says Electric Clutch
using a 2-Pin Shroud and Cavity Plug to protect it
from the environment. See Figure 2-14.
6. Connect plug labeled "Left Front Seed Shaft Sensor"
to the left front Seed Shaft Sensor. Seal the plug end
using a 3-Pin Tower and Cavity Plugs to protect it
from the environment.
7. Repeat for the right side.
8. Secure all harnesses and wires with cable tie and tie
straps.
1P342