3D Menu - Digital Projection E-Vision Laser 13000 WU Series Installation & Quick Start Manual

3D menu

Use this menu to enable, disable and set up 3D input, as follows:
3D Format — Off, Dual Pipe and Frame Sequential.
l
Frame Sequential is for sources where Left and Right eye images are delivered as alternate frames from
a single input. Dual Pipe is for sources where Left and Right eye are delivered on separate inputs.
DLP Link — Off / On.
l
DLP Link On emits a sync pulse for the 3D glasses via the projected image. DLP Link Off will send the
sync pulse to the sync out connector to use with an external third party emitter.
Eye Swap — Normal and Reverse.
l
(set to Reverse if the left- and right-eye images are displayed in the wrong order)
Dark Time — 0.65 ms, 1.3 ms and 1.95 ms.
l
Set to reduce the effect of banding and image overlapping when viewed through 3D glasses.
3D Sync
Offset.
l
Use the LEFT and RIGHT arrow buttons to compensate for image overlapping (ghosting) when viewed
through 3D glasses.
Reference— External and Internal.
l
Select the source of the 3D sync. Internal is referenced to the incoming video. External is for Frame
Sequential 3D sources and is supplied by the graphics card or player.
Operating Guide
Using the projector
3D Format
DLP Link
Eye Swap
Dark Time
3D Sync
Offset
Reference
Digital Projection Ltd. E-Vision Laser 13000 WU Series
3D
If 3D Format is set to Off,
all other 3D settings will
Auto
be unavailable.
Off
See 3D connections on
Normal
page 28 for more
1.95 ms
information about
supported 3D formats.
The following settings are
100
not available when 3D is
on:
Internal
Image > Brightness,
Contrast, Saturation, Hue,
Sharpness, Noise
Reduction, Freeze,
Resync.
Color > Color Space.
Geometry > Aspect Ratio,
Digital Zoom, Overscan.
Setup > Screen Setting,
Auto Source, Trigger-1,
Trigger-2.
PIP > all settings.
Also: See 3D types on the
next page and See Some
3D settings explained on
page 73
See 3D formats on
page 109 for 3D
resolutions and frame
rates.
Notes
Rev A June 2019
page 71