Replacing The Solenoid Valve Block; Replacing A Solenoid Of The Solenoid Valve Block - Bosch EPS 708 Repair Instructions

6.26

Replacing the solenoid valve block

6.26.1 Removing the solenoid valve block
i
Get a cloth ready for catching and mopping up
calibrating oil.
i
To ensure sufficient working space when removing
and installing the solenoid valve, we recommend
also removing the neighboring solenoids.
Fig. 95: Pressure control valve block and solenoid valve block
1. Remove the valve support (see section 6.22.1).
2. Remove the solenoid valve block (item 1) from the
valve support.
6.26.2 Installing the solenoid valve block
¶
Install the solenoid valve block in the reverse order.
Tightening torque: 15 Nm.
Robert Bosch GmbH
1
2
Repair | EPS 708 | 55
6.27 Replacing a solenoid of the solenoid
valve block
Fig. 96: Solenoid valve block
1. Remove the solenoid valve block from the EPS 708
(see section 6.26.1). Then proceed as described in
this section.
2. Remove the hexagon nut (item 1).
3. Remove the solenoid (item 2).
4. Install a new solenoid.
5. Install the solenoid valve block in the EPS 708 in the
reverse order.
en
1
2
|
1 689 975 233 2018-05-08