Mitsubishi Electric MR-J4-*B-RJ010 Series Instruction Manual page 41

1. FUNCTIONS AND CONFIGURATION
(2) MR-J4-350B-RJ010/MR-J4-500B-RJ010/MR-J4-700B-RJ010
(a) Removal of the side cover
a)
1)
b)
(b) Installation of MR-J3-T10
Guide hole
a)
1)
1)
Guide pin
2)
Knob
(c) Removal of MR-J3-T10
a)
2) 2)
b)
3)
1)
1) Keep pushing the knobs ( a) , b) ) and pull out the side
cover to the arrow direction.
1) Find the guide hole on the side of the servo amplifier. To
the guide hole, insert the MR-J3-T10's guide pins.
2) Push MR-J3-T10 until the knobs click.
3) Tighten the unit with the enclosed installing screw (M4).
1) Remove the installing screw.
2) Keep pushing the knobs ( a) , b) ) and pull out MR-J3-T10
to the arrow direction. Avoid pulling out MR-J3-T10 while it
is tightened with the installation screw.
1 - 30