Mitsubishi Electric MR-J4-*B-RJ010 Series Instruction Manual page 84

4. STARTUP
(1) Test operation select switch (SW2-1)
To use the test operation mode, turn "ON (up)" the switch. Turning "ON (up)" the switch enables the test
operation mode. In the test operation mode, the functions such as JOG operation, positioning operation,
and machine analyzer are available with MR Configurator2.
(2) Switches for setting station No.
You can set the station No. between 1 and 63 by using the auxiliary station number setting switches with
the station number setting rotary switch. (Refer to (2) (c) in this section.)
If the same numbers are set to different stations in a single communication system, the system will not
operate properly. The station numbers may be set independently of the CC-Link IE cable connection
sequence. The following shows the description of each switch.
(a) Auxiliary station number setting switches (SW2-3 and SW2-4)
Turning these switches "ON (up)" enables you to set the station No. 16 or more.
(b) Station number setting rotary switch (SW1)
You can set the station No. between 1 and 63 by using auxiliary station number setting switches with
this switch. (Refer to (2) (c) of this section.)
ON
1 2 3 4
Test operation select switch
Turn it "ON (up)".
POINT
Set a station No. with the auxiliary station number setting switches (SW2-3,
SW2-4) and station number setting rotary switch (SW1). When connecting the
amplifier to the Mitsubishi simple motion module QD77GF_, set the station No.
between 1 and 16.
For setting the station number setting rotary switch, use a flat-blade screwdriver
with the blade edge width of 2.1 mm to 2.3 mm and the blade edge thickness of
0.6 mm to 0.7 mm.
When connecting the amplifier to the Mitsubishi simple motion module
QD77GF_, set the station No. between 1 and 16.
Station number setting rotary switch (SW1)
8
4 - 7