Mitsubishi Electric MR-J4-*B-RJ010 Series Instruction Manual page 4

3. To prevent injury, note the following
Only the voltage specified in the Instruction Manual should be applied to each terminal. Otherwise, a
burst, damage, etc. may occur.
Connect cables to the correct terminals. Otherwise, a burst, damage, etc. may occur.
Ensure that polarity (+/-) is correct. Otherwise, a burst, damage, etc. may occur.
The servo amplifier heat sink, regenerative resistor, servo motor, etc. may be hot while power is on or for
some time after power-off. Take safety measures, e.g. provide covers, to avoid accidentally touching the
parts (cables, etc.) by hand.
4. Additional instructions
The following instructions should also be fully noted. Incorrect handling may cause a malfunction, injury,
electric shock, etc.
(1) Transportation and installation
Transport the products correctly according to their mass.
Stacking in excess of the specified number of product packages is not allowed.
Do not hold the front cover when transporting the servo amplifier. Otherwise, it may drop.
Install the servo amplifier and the servo motor in a load-bearing place in accordance with the Instruction
Manual.
Do not get on or put heavy load on the equipment.
The equipment must be installed in the specified direction.
Leave specified clearances between the servo amplifier and the cabinet walls or other equipment.
Do not install or operate the servo amplifier and MR-J3-T10 which have been damaged or have any
parts missing.
Do not block the intake and exhaust areas of the servo amplifier and MR-J3-T10. Otherwise, it may
cause a malfunction.
Do not drop or strike the servo amplifier, servo motor, and MR-J3-T10. Isolate them from all impact
loads.
When you keep or use the equipment, please fulfill the following environment.
Item
Ambient Operation
temperature
Storage
Operation
Ambient
humidity
Storage
Ambience
Altitude
Vibration resistance
When the product has been stored for an extended period of time, contact your local sales office.
When handling the servo amplifier and MR-J3-T10, be careful about the edged parts such as corners of
them.
The servo amplifier and MR-J3-T10 must be installed in a metal cabinet.
When fumigants that contain halogen materials such as fluorine, chlorine, bromine, and iodine are used
for disinfecting and protecting wooden packaging from insects, they cause malfunction when entering our
products. Please take necessary precautions to ensure that remaining materials from fumigant do not
enter our products, or treat packaging with methods other than fumigation (heat method).Additionally,
disinfect and protect wood from insects before packing products.
CAUTION
CAUTION
90 %RH or less (non-condensing)
Indoors (no direct sunlight), free from corrosive gas, flammable gas, oil mist, dust, and dirt
2
5.9 m/s , at 10 Hz to 55 Hz (directions of X, Y and Z axes)
A - 3
Environment
0 °C to 55 °C (non-freezing)
-20 °C to 65 °C (non-freezing)
1000 m or less above sea level