Mitsubishi Electric MR-J4-*B-RJ010 Series Instruction Manual page 40

1. FUNCTIONS AND CONFIGURATION
(1) MR-J4-350B-RJ010 or smaller capacity models
(a) Installation of MR-J3-T10
1)
Guide pin
Knob
(b) Removal of MR-J3-T10
a)
2) 2)
b)
POINT
Do not remove the cover of the CN9 connector because the connector is not
used.
Guide hole
MR-J3-T10
2)
2)
4)
1)
1) Remove the cover of connector for connecting an option.
Make sure to store the removed cover.
2) Find the guide hole on the side of the servo amplifier. To
the guide hole, insert the MR-J3-T10's guide pins.
3) Push the four corners of the side of MR-J3-T10
simultaneously to the servo amplifier until the four knobs
click so that the CN7 connector is connected straight.
4) Tighten the unit with the enclosed installing screw (M4).
1) Remove the installing screw.
2) Keep pushing the knobs ( a) , b) ) and pull out MR-J3-T10
to the arrow direction. Avoid pulling out MR-J3-T10 while it
is tightened with the installation screw.
After removing MR-J3-T10, make sure to cap the
connector for connecting an option to avoid dust
and dirt.
1 - 29