Hardware Maintenance; Tool Preparation; Parts Replacement - Inspur NX5460M4 User Manual

5 Hardware Maintenance

5.1 Tool Preparation

● Necessary tools are shown in the following table.
Tool List

5.2 Parts Replacement

Special tips: Except hot-swappable parts (i.e. hot-swappable disk drives), all part
replacements could only be carried out with power disconnected.
5.2.1 CPU Replacement
During installing and replacing the CPU, please pay attention to the following issues:
● If installing two CPUs, type of these two CPUs shall be the same.
● If only one CPU is to be installed, please operate according to the following
requirements:
1) This CPU has to be installed on CPU0's socket.
2) It is not allowed to dismantle the protective cover on socket1 without CPU1 installed.
５０
Illustration Name
Phillips
Used to fix screws.
Screwdriver
Used to contact or operate
Anti-static Wrist
devices and apparatus, to prevent
Strap
electrostatic discharge.
Used to plug in the single board,
hand-held single board or other
Anti-static
precision instruments, to prevent
Gloves
electrostatic discharge.
Description