2.4 CLR_CMOS Jumper Introduction
The jumper position is shown in the following figure:
Jumper No.
CLR_CMOS
Note:
It is required to shut down the system, as well as disconnect power supply during
CMOS clearing, and hold for 5 seconds after short-circuiting Pin2-3; then short-circuit Pin1
and Pin2 of CLR_CMOS jumper (the default status) with a jumper cap, to restore to its
original status.
8
Name
CMOS clear jumper
Jumper Functions
Short-circuit pin1-2, to restore normal status; short-
circuit pin2-3, to clear CMOS.