Inspur NX5460M4 User Manual page 49

The RAID setting interface is as shown below; after selection, press Enter to set the next
item. After all settings finished, move the cursor to 【 Done 】 option and press Enter to finish
the RAID creation.
Array Type: Select RAID array type, including two options of RAID0 (Stripe) and
RAID1 (Mirror), please select according to the actual needs.
RAID0: allow 2 or more hard disks to make this RAID.
RAID1: allow 2 hard disks to make this RAID.
Array Size: Set the array size, it defaults to the maximum size.
Stripe Size: Select the stripe size.
After finishing the above settings, please select 【 Done 】 and press Enter. System will
prompt "WARNING ： ALL DATA ON SELECTED DISKS WILL BE LOST. Are you sure
you want to create this volume ?(Y/N):" If you want to create the RAID volume, please input
Y, and all of the data in selected hard disks will be lost. If you don't want to create the RAID
４６