Set BMC static network parameter
1) Set the option of Configuration Address source to 【 Static 】 , and the BMC network
will be set to static at once, as shown in the following figure:
2) Select the option of Station IP address, press Enter, manually input the Static IP in the
pop-up window, and press Enter to confirm;
If the entered IP is invalid, there will be a prompt of "Invalid Station IP Entered!!!",
and assign the IP address as 0.0.0.0; here the assignment just changes the IP address in BIOS
setup interface, won't trigger IPMI command to change BMC IP.
Subnet mask setting is similar to Station IP address setting, and will not be explained
here. After setting, BMC network parameters will take effect, as shown in the following
figure, users can login BMC Web interface to operate.
BIOS Setup
37