Table of Contents
Advertisement
MVME162LX Module Installation
With EPROMs and IndustryPacks installed and the controller's headers
properly configured, proceed as follows to install the controller in the
VME chassis:
1. Turn all equipment power OFF and disconnect the power cable
Dangerous voltages, capable of causing death, are present
!
in this equipment. Use extreme caution when handling,
Warning
testing, and adjusting.
!
To prevent damage to the controller's components, do not
Caution
install or remove the controller with the power applied.
2. Remove the chassis cover as instructed in the user's manual for the
3. Remove the filler panel from the card slot where you are going to
4. Slide the controller into the selected card slot. Ensure it is seated
5. Secure the controller in the chassis with the screws provided,
http://www.mcg.mot.com/literature
from the AC power source.
equipment.
install the controller.
– If you intend to use the MVME162LX as system controller, it
must occupy the leftmost card slot (slot 1). The system controller
must be in slot 1 to correctly initiate the bus-grant daisy-chain
and to ensure proper operation of the IACK daisy-chain driver.
– If you do not intend to use the MVME162LX as system
controller, it can occupy any unused double-height card slot.
properly in the P1 and P2 connectors on the backplane. Do not
damage or bend connector pins.
making good contact with the transverse mounting rails to minimize
RF emissions.
Installation Instructions
2-13
2
Advertisement
Table of Contents
